A LIFT GARAGE DOOR (214) 831-2545 Book Online
Broken torsion spring above a white sectional garage door: the coils have snapped and pulled apart, leaving a clear gap of bare winding shaft between the two halves of the spring.

Westlake, Tarrant County

Broken Spring Replacement in Westlake, TX

Most spring jobs in Westlake are done within an hour to ninety minutes of us pulling up. The truck carries the common wire sizes and lengths. We leave with the door balancing by hand and the opener reset to the fixed door instead of the broken one.

  • Emergency and same-day repairs
  • 5.0 from 10 reviews
  • Upfront pricing, no hidden fees
  • Free estimates

Torsion and extension springs are two different systems

Torsion springs sit on a shaft above the door. That is what most doors built in the last few decades use. Extension springs run along the horizontal tracks on both sides, stretch when the door closes, and pull back to help lift it. Plenty of older and lighter doors still have them. Here is the part that matters: an extension spring needs a safety cable run through the middle of it and anchored at both ends. Without that cable, a spring that snaps becomes a length of steel whipping across your garage. If your door has extension springs and no safety cables, we will put them in. They are cheap.

Both springs get replaced, not just the broken one

Both springs went on the same day and have taken the exact same number of cycles. When one hits the end, the other is right behind it. Beyond that, springs get sized as a matched pair against the door weight, so a new one working next to a fatigued one puts uneven torque across the shaft and the door never balances properly through its travel. Two service calls also cost more than one. This is not an upsell, it is the reason you are not calling us again in four months.

Sizing is measuring, not eyeballing

A torsion spring is defined by four things: wire diameter, inside diameter, length, and which way it winds. Those decide how much torque you get per turn. Picking the replacement means knowing what the door weighs, either by putting it on a scale with the springs off or by calculating from the panel construction and hardware. Too light a spring and the door stays heavy at the floor and burns through cycles fast. Too heavy and the door wants to fly open and the opener fights it all the way down. Both feel more or less fine on day one. Both cut the life of everything they are bolted to.

Broken Spring Replacement for Westlake homes

A very small town of large estate properties, where four-car and motor-court garages with custom wood or full-view glass doors are the standard rather than the exception.

That ZIP code are ours: 76262.

Vaquero, Granada and Terra Bella account for a steady share of our Westlake work.

Anywhere around Vaquero Club is a short run for us.

Westlake sits in Tarrant County with a population of about 2,017.

Please do not attempt this one yourself

That spring is still loaded even with the door down. People get badly hurt trying to unwind one with the wrong tools. Leave the door shut, do not pull the release, and call us.

What you are probably seeing

  • Opener strains, moves the door a few inches, then stops or reverses.
  • Door is extremely heavy by hand and will not stay up.
  • Door goes up crooked with one side behind the other.
  • Top panel flexes or bends when the opener pulls on it.
  • Cables have gone slack or jumped off the drums.

Westlake service

Call (214) 831-2545 or request a visit.

The visit

How a Westlake call runs

  1. Confirm it and secure the door

    We find which spring broke, check whether the other one is still loaded, and clamp or block the door so it cannot move while we work. Opener stays disconnected the whole time.

  2. Measure the door and the old springs

    Wire diameter, inside diameter, length and wind direction come off the existing springs, and we establish what the door weighs. That decides the replacement. Not a visual match.

  3. Unwind and strip it

    Any leftover tension comes off with proper winding bars, cables come off the drums, old springs come off the shaft. We check the bearings, drums and shaft while we can actually see them.

  4. New pair, wound to the right turn count

    Both springs go on. Cables get set in the drums with equal tension so the door lifts square. Springs get wound to the turns this door needs, not to a default number.

  5. Balance by hand, then reset the opener

    Door gets lifted by hand and checked at several heights to make sure it holds position. Then the opener goes back on, travel and force get reset, and we test the safety reverse.

On the job

Broken Spring Replacement in the field

Questions

Broken Spring Replacement in Westlake

Can I replace a torsion spring myself?

No. That is the one flat no on this whole site. It takes correctly sized steel winding bars, properly seated set screws, and a stance that keeps your body out of the arc of those bars. Improvised tools slipping under that kind of torque send people to the emergency room every year. Almost everything else on a garage door is fair game for a handy person. This is not.

Why do both springs have to go?

Same install date, same cycle count, so the second one is close behind the first. And springs get sized as a pair against the door weight, so a new one next to an old one never balances the door right through its travel. Doing it once costs less than doing it twice.

Can I get my car out before you arrive?

Sometimes, carefully, with help. With the opener released the door weighs everything it weighs, often over 200 pounds on a double. Two adults can usually manage it. Block it open with something solid, never with a person holding it, while the car comes out. Do not run the opener, because that is how a spring job turns into a spring, cable and opener job.

Should the cables be done at the same time?

Only if they need it, and we will show you. If the cable is fraying at the drum or at the bottom bracket, do it now, because the labor overlaps almost completely and you save a whole visit. If the cables are clean, leave them alone. A spring breaking does not damage a good cable.

Does a broken spring wreck the opener?

Running the door on it will, given enough tries. The opener suddenly has to move the full weight, and what gives out is the drive gear, the trolley, the arm, or the top panel where the arm attaches. One or two presses before you figured out what happened is usually harmless. Twenty is not.

Book a visit that fits your day

Broken Spring Replacement in Westlake and across Tarrant County.

Call Now Book