A LIFT GARAGE DOOR (214) 831-2545 Book Online
Two-car garage photographed from between the parked cars, with a white insulated sectional door closed, a pair of torsion springs on the shaft above it, an opener and its rail overhead and a ceiling storage rack to the left.

Willow Park, Parker County

Broken Spring Replacement in Willow Park, TX

First hard freeze breaks springs all over North Texas. Cold steel is a little less forgiving, so a spring already near the end of its life goes on the coldest morning instead of a mild one. If yours snapped overnight in Willow Park, that is normal and it is not something you did.

  • Emergency and same-day repairs
  • 5.0 from 10 reviews
  • Upfront pricing, no hidden fees
  • Free estimates

Why this is the job we tell people to stay off of

The broken spring is not the danger. It already let go. The danger is everything else still loaded. On a two spring door, the other spring is still fully wound. Both bottom brackets are still under the full pull of that counterbalance, which is exactly why the factory puts a warning label on them. Winding a torsion spring takes steel winding bars seated in the cone holes. Wrong size bar, loose set screw, or a hand slipping, and the bar comes out at speed with hundreds of pounds behind it. Emergency rooms see these. They are hand, wrist, face and teeth injuries. People use screwdrivers and rebar because that is what is in the garage, and that is how most of it happens.

Torsion and extension springs are two different systems

Torsion springs sit on a shaft above the door. That is what most doors built in the last few decades use. Extension springs run along the horizontal tracks on both sides, stretch when the door closes, and pull back to help lift it. Plenty of older and lighter doors still have them. Here is the part that matters: an extension spring needs a safety cable run through the middle of it and anchored at both ends. Without that cable, a spring that snaps becomes a length of steel whipping across your garage. If your door has extension springs and no safety cables, we will put them in. They are cheap.

Both springs get replaced, not just the broken one

Both springs went on the same day and have taken the exact same number of cycles. When one hits the end, the other is right behind it. Beyond that, springs get sized as a matched pair against the door weight, so a new one working next to a fatigued one puts uneven torque across the shaft and the door never balances properly through its travel. Two service calls also cost more than one. This is not an upsell, it is the reason you are not calling us again in four months.

Broken Spring Replacement for Willow Park homes

An I-20 commuter city of 1980s-2000s homes on wooded half-acre-plus lots, where side-entry three-car garages and separate shop buildings are the common pattern.

Our route through Willow Park takes in 76087.

We are in Crown Pointe and Willow Park Village most weeks.

Anywhere around Interstate 20 corridor is a short run for us.

Willow Park is a Parker County community of roughly 6,851.

Please do not attempt this one yourself

That spring is still loaded even with the door down. People get badly hurt trying to unwind one with the wrong tools. Leave the door shut, do not pull the release, and call us.

What you are probably seeing

  • A two to three inch gap in the coil of the spring above the door.
  • Opener strains, moves the door a few inches, then stops or reverses.
  • Door is extremely heavy by hand and will not stay up.
  • Door goes up crooked with one side behind the other.
  • Top panel flexes or bends when the opener pulls on it.

Willow Park service

Call (214) 831-2545 or request a visit.

The visit

How a Willow Park call runs

  1. Confirm it and secure the door

    We find which spring broke, check whether the other one is still loaded, and clamp or block the door so it cannot move while we work. Opener stays disconnected the whole time.

  2. Measure the door and the old springs

    Wire diameter, inside diameter, length and wind direction come off the existing springs, and we establish what the door weighs. That decides the replacement. Not a visual match.

  3. Unwind and strip it

    Any leftover tension comes off with proper winding bars, cables come off the drums, old springs come off the shaft. We check the bearings, drums and shaft while we can actually see them.

  4. New pair, wound to the right turn count

    Both springs go on. Cables get set in the drums with equal tension so the door lifts square. Springs get wound to the turns this door needs, not to a default number.

  5. Balance by hand, then reset the opener

    Door gets lifted by hand and checked at several heights to make sure it holds position. Then the opener goes back on, travel and force get reset, and we test the safety reverse.

On the job

Broken Spring Replacement in the field

Questions

Broken Spring Replacement in Willow Park

Can I replace a torsion spring myself?

No. That is the one flat no on this whole site. It takes correctly sized steel winding bars, properly seated set screws, and a stance that keeps your body out of the arc of those bars. Improvised tools slipping under that kind of torque send people to the emergency room every year. Almost everything else on a garage door is fair game for a handy person. This is not.

How long will the new springs last?

Take the cycle rating and divide by how many times a day you open the door. A standard 10,000 cycle spring is four to five years at six openings a day, or about fourteen years at two. If your house is on the heavy end, ask about high cycle springs at 20,000 or more. The price difference is small next to a second replacement.

Can I get my car out before you arrive?

Sometimes, carefully, with help. With the opener released the door weighs everything it weighs, often over 200 pounds on a double. Two adults can usually manage it. Block it open with something solid, never with a person holding it, while the car comes out. Do not run the opener, because that is how a spring job turns into a spring, cable and opener job.

Did I break it?

No. Springs fail from metal fatigue after a counted number of cycles, and they usually go on a cold morning because the steel is less forgiving then. The two things that actually shorten spring life are a spring undersized for the door at install and rust pitting on the coil. Neither one is about how you use the door.

Does a broken spring wreck the opener?

Running the door on it will, given enough tries. The opener suddenly has to move the full weight, and what gives out is the drive gear, the trolley, the arm, or the top panel where the arm attaches. One or two presses before you figured out what happened is usually harmless. Twenty is not.

Need this handled today?

Broken Spring Replacement in Willow Park and across Parker County.

Call Now Book