A LIFT GARAGE DOOR (214) 831-2545 Book Online
Torsion spring, winding cones and shaft mounted above the windowed top section of a garage door, with the opener rail, door arm and red release cord alongside, lit by daylight through the door glass.

Arlington Heights, Fort Worth, Tarrant County

New Garage Door Installation in Arlington Heights, Fort Worth, TX

August is when people in Arlington Heights, Fort Worth finally notice the garage door. An uninsulated steel door facing west radiates heat all afternoon into the garage and into whatever room shares a wall with it. If that is your house, insulation is the line item worth spending on.

  • Emergency and same-day repairs
  • 5.0 from 10 reviews
  • Upfront pricing, no hidden fees
  • Free estimates

The five measurements that decide what fits

Width and height of the opening are the obvious two. The three that decide the hardware are headroom, backroom and side room. Standard track wants about twelve inches of clear headroom above the opening, more if a rail opener is going on that ceiling. Low headroom kits get that down to around four and a half inches using double track and split drums. Backroom needs the door height plus about eighteen inches of clear depth. Side room needs about three and three quarter inches on each side for the vertical track. If one of those comes up short, the fix is a different track setup, not a smaller door.

Insulation, and what it buys you in Texas

Polystyrene board gets cut and fitted into the panel and lands somewhere around R-6 to R-9. Injected polyurethane foam expands and bonds both skins together, which is why those doors hit R-12 to R-18 and are stiffer at the same time. Around here the summer case is much stronger than the winter one. A garage that stays twenty degrees cooler in August is a garage you can use. And if there is a bedroom or a bonus room over it, the insulated door pulls real load off that room's air conditioning all season.

What happens to your old door

Removal starts by unwinding the torsion springs with winding bars so the stored energy comes off in a controlled way. Only then do the cables come off the drums and the sections come down from the top, one at a time, so no section is ever holding up the ones above it. Old panels, track, springs and hardware leave with us. The steel goes to recycling, not to your curb.

New Garage Door Installation for Arlington Heights, Fort Worth homes

A 1920s-40s streetcar neighbourhood off Camp Bowie where brick Tudors sit on alley-loaded lots with detached garages that frequently need low-headroom track conversions.

Our route through Arlington Heights, Fort Worth takes in 76107.

We are in Crestline, Monticello and Rivercrest most weeks.

If you are near Trinity Trails, you are well inside our route.

Arlington Heights is part of Fort Worth, in Tarrant County.

What you are probably seeing

  • The bottom section is rusted or swollen from sitting on a wet slab.
  • You can see daylight all the way around a closed door with a good seal.
  • The door visibly flexes in the middle as it starts to lift.
  • Hinges have torn out and the steel around them is cracked.
  • The garage is unusable in summer and the door is the biggest uninsulated surface in it.

Arlington Heights, Fort Worth service

Call (214) 831-2545 or request a visit.

The visit

How a Arlington Heights, Fort Worth call runs

  1. Measure and spec

    Opening, headroom, backroom, side room, jamb and header condition, and whether the existing opener is worth keeping. You get options at more than one construction level with the tradeoffs explained, not one recommended package.

  2. Order with a real lead time

    Stock sizes and finishes move quickly. Custom widths, specialty finishes and window inserts take longer, and you get that number before the deposit rather than after.

  3. Take the old one down safely

    Springs unwound with winding bars, cables released from the drums, sections down from the top in order. Old track, hardware and springs go with us.

  4. Install and set the counterbalance

    Sections stack from the bottom with hinges and rollers set as they go, track gets lagged into solid framing and aligned, then shaft, drums and springs go in and get wound to the turn count the finished door weight calls for.

  5. Commission it

    Door gets run by hand to confirm balance, opener travel and force get set, sensors get mounted within six inches of the floor, the auto reverse gets tested against an obstruction, and we walk you through the manual release before we leave.

On the job

New Garage Door Installation in the field

Questions

New Garage Door Installation in Arlington Heights, Fort Worth

Can I keep my existing opener?

Usually, if it is mechanically sound and has working photo eyes. Two things to watch. A much heavier insulated door asks more of an older half horsepower unit. And the opener arm needs a properly reinforced top section, which may mean adding a strut. If the opener is old enough to have no photo eyes, replace it regardless of the door.

Is insulation worth it if the garage is not heated or cooled?

Depends what is above it and what you do in there. Parking only, nothing conditioned next to it, and the payback is just comfort during the hours you are out there, which for a lot of people is not much. Room above, workshop inside, or a door straight into the kitchen, and the insulated door is clearly the better buy.

Do you replace the track too?

Yes, always. Reusing old track on a new door is false economy. Vertical track carries the door's alignment, old track is worn where the rollers ride and usually a little out of plumb, and any of that transfers straight into your new panels and rollers.

What is the warranty?

It comes from the manufacturer and it varies a lot by model on panels, hardware, springs and finish. We hand you the written terms for the specific door you pick instead of summarizing it verbally, because the actual limits are in that document.

Can I install a door myself?

Stacking sections and hanging track is doable if you build things. Winding the torsion springs is not, and that is not us protecting a sale. Winding bars under several hundred pounds of torque break arms and jaws when they slip. If you install it yourself, hire out the spring work.

Need this handled today?

New Garage Door Installation in Arlington Heights, Fort Worth and across Tarrant County.

Call Now Book