Hurst, Tarrant County
New Garage Door Installation in Hurst, TX
The price of a new door comes down to four choices: steel gauge, insulation type, hardware grade, and whether your opening needs standard track or a low headroom setup. Two of those four you cannot see from the street in Hurst, and that is exactly where a cheap install saves money out of your pocket.
- Emergency and same-day repairs
- 5.0 from 10 reviews
- Upfront pricing, no hidden fees
- Free estimates
The five measurements that decide what fits
Width and height of the opening are the obvious two. The three that decide the hardware are headroom, backroom and side room. Standard track wants about twelve inches of clear headroom above the opening, more if a rail opener is going on that ceiling. Low headroom kits get that down to around four and a half inches using double track and split drums. Backroom needs the door height plus about eighteen inches of clear depth. Side room needs about three and three quarter inches on each side for the vertical track. If one of those comes up short, the fix is a different track setup, not a smaller door.
The springs have to be sized for the new door, not the old one
Springs match weight, and a new door rarely weighs what the old one did. An insulated three layer door can be eighty pounds heavier than the single layer it replaces. Reuse the old springs on that and the counterbalance never balances, the opener carries the difference every cycle, and the springs burn through their cycle life early. We weigh the assembled door or calculate it from panel construction and hardware, then pick wire size, inside diameter and length to match. It is the part of the install nobody sees and it decides how the door feels for the next ten years.
What happens to your old door
Removal starts by unwinding the torsion springs with winding bars so the stored energy comes off in a controlled way. Only then do the cables come off the drums and the sections come down from the top, one at a time, so no section is ever holding up the ones above it. Old panels, track, springs and hardware leave with us. The steel goes to recycling, not to your curb.
New Garage Door Installation for Hurst homes
A compact 1960s-70s suburb where narrow single and early double garages under low headers are common, and standard-lift torsion conversions are a frequent fix.
We cover ZIP codes 76053 and 76054.
Hurst Hills, Redbud and Bellaire account for a steady share of our Hurst work.
If you are near Hurst Conference Center, you are well inside our route.
Hurst sits in Tarrant County with a population of about 39,500.
What you are probably seeing
- Several sections are dented and the dents have creased, not just dimpled.
- The bottom section is rusted or swollen from sitting on a wet slab.
- You can see daylight all the way around a closed door with a good seal.
- The door visibly flexes in the middle as it starts to lift.
- Hinges have torn out and the steel around them is cracked.
Hurst service
Call (214) 831-2545 or request a visit.
The visit
How a Hurst call runs
Measure and spec
Opening, headroom, backroom, side room, jamb and header condition, and whether the existing opener is worth keeping. You get options at more than one construction level with the tradeoffs explained, not one recommended package.
Order with a real lead time
Stock sizes and finishes move quickly. Custom widths, specialty finishes and window inserts take longer, and you get that number before the deposit rather than after.
Take the old one down safely
Springs unwound with winding bars, cables released from the drums, sections down from the top in order. Old track, hardware and springs go with us.
Install and set the counterbalance
Sections stack from the bottom with hinges and rollers set as they go, track gets lagged into solid framing and aligned, then shaft, drums and springs go in and get wound to the turn count the finished door weight calls for.
Commission it
Door gets run by hand to confirm balance, opener travel and force get set, sensors get mounted within six inches of the floor, the auto reverse gets tested against an obstruction, and we walk you through the manual release before we leave.
On the job
New Garage Door Installation in the field
Questions
New Garage Door Installation in Hurst
Can I keep my existing opener?
Usually, if it is mechanically sound and has working photo eyes. Two things to watch. A much heavier insulated door asks more of an older half horsepower unit. And the opener arm needs a properly reinforced top section, which may mean adding a strut. If the opener is old enough to have no photo eyes, replace it regardless of the door.
How much headroom do I need?
About twelve inches above the opening for standard track. Less than that and you are looking at a low headroom conversion with double track and split drums, which works in roughly four and a half to six inches, or a wall mount opener that gets rid of the ceiling rail entirely. Both cost more, so measure before you pick a setup.
How long does the install take?
Four to six hours for a standard single or double door on sound framing, including removal. Add time for jamb repair, low headroom conversion, or a second door. We do not leave a door half installed overnight.
Will the color match my trim?
Steel doors come in a range of stamped designs and factory colors, and overlay carriage house looks are available too. Honest warning: a factory color and hand mixed trim paint almost never match perfectly. If an exact match matters, get a paintable primed door and finish it on site.
Can I install a door myself?
Stacking sections and hanging track is doable if you build things. Winding the torsion springs is not, and that is not us protecting a sale. Winding bars under several hundred pounds of torque break arms and jaws when they slip. If you install it yourself, hire out the spring work.
Nearby
Also serving around Hurst
Talk to a technician now
New Garage Door Installation in Hurst and across Tarrant County.