Pantego, Tarrant County
New Garage Door Installation in Pantego, TX
A garage door is one of the few things you can replace where it looks better and works better on the same day. We will show you what fits your opening in Pantego, including the options we would not put on our own house and why.
- Emergency and same-day repairs
- 5.0 from 10 reviews
- Upfront pricing, no hidden fees
- Free estimates
Gauge and construction, in plain English
Steel thickness is a gauge number and it runs backwards: 24 gauge is thicker than 25 or 27. A single layer door is one sheet of steel with nothing behind it. Two layer adds insulation bonded to the back. Three layer, sometimes called sandwich, puts a second steel skin behind the insulation, and that is what actually makes the panel stiff instead of just warm. Stiffness matters more than people expect. A rigid panel shrugs off the twisting force the opener and hinges apply thousands of times, and it takes a hail hit without folding the whole section.
Insulation, and what it buys you in Texas
Polystyrene board gets cut and fitted into the panel and lands somewhere around R-6 to R-9. Injected polyurethane foam expands and bonds both skins together, which is why those doors hit R-12 to R-18 and are stiffer at the same time. Around here the summer case is much stronger than the winter one. A garage that stays twenty degrees cooler in August is a garage you can use. And if there is a bedroom or a bonus room over it, the insulated door pulls real load off that room's air conditioning all season.
The springs have to be sized for the new door, not the old one
Springs match weight, and a new door rarely weighs what the old one did. An insulated three layer door can be eighty pounds heavier than the single layer it replaces. Reuse the old springs on that and the counterbalance never balances, the opener carries the difference every cycle, and the springs burn through their cycle life early. We weigh the assembled door or calculate it from panel construction and hardware, then pick wire size, inside diameter and length to match. It is the part of the install nobody sees and it decides how the door feels for the next ten years.
New Garage Door Installation for Pantego homes
A one-square-mile town enclaved by Arlington, built mainly in the 1960s with attached two-car garages on flat lots and a small commercial strip on roll-up doors.
That ZIP code are ours: 76013.
Anywhere around Pantego Town Hall is a short run for us.
Pantego sits in Tarrant County with a population of about 2,495.
What you are probably seeing
- It is still a one piece tilt up door, which limits parts and eats headroom.
- Two years of repair bills are adding up to a real chunk of a new door.
- Several sections are dented and the dents have creased, not just dimpled.
- The bottom section is rusted or swollen from sitting on a wet slab.
- You can see daylight all the way around a closed door with a good seal.
Pantego service
Call (214) 831-2545 or request a visit.
The visit
How a Pantego call runs
Measure and spec
Opening, headroom, backroom, side room, jamb and header condition, and whether the existing opener is worth keeping. You get options at more than one construction level with the tradeoffs explained, not one recommended package.
Order with a real lead time
Stock sizes and finishes move quickly. Custom widths, specialty finishes and window inserts take longer, and you get that number before the deposit rather than after.
Take the old one down safely
Springs unwound with winding bars, cables released from the drums, sections down from the top in order. Old track, hardware and springs go with us.
Install and set the counterbalance
Sections stack from the bottom with hinges and rollers set as they go, track gets lagged into solid framing and aligned, then shaft, drums and springs go in and get wound to the turn count the finished door weight calls for.
Commission it
Door gets run by hand to confirm balance, opener travel and force get set, sensors get mounted within six inches of the floor, the auto reverse gets tested against an obstruction, and we walk you through the manual release before we leave.
On the job
New Garage Door Installation in the field
Questions
New Garage Door Installation in Pantego
How much headroom do I need?
About twelve inches above the opening for standard track. Less than that and you are looking at a low headroom conversion with double track and split drums, which works in roughly four and a half to six inches, or a wall mount opener that gets rid of the ceiling rail entirely. Both cost more, so measure before you pick a setup.
How long does the install take?
Four to six hours for a standard single or double door on sound framing, including removal. Add time for jamb repair, low headroom conversion, or a second door. We do not leave a door half installed overnight.
Do you replace the track too?
Yes, always. Reusing old track on a new door is false economy. Vertical track carries the door's alignment, old track is worn where the rollers ride and usually a little out of plumb, and any of that transfers straight into your new panels and rollers.
Will the color match my trim?
Steel doors come in a range of stamped designs and factory colors, and overlay carriage house looks are available too. Honest warning: a factory color and hand mixed trim paint almost never match perfectly. If an exact match matters, get a paintable primed door and finish it on site.
Can I install a door myself?
Stacking sections and hanging track is doable if you build things. Winding the torsion springs is not, and that is not us protecting a sale. Winding bars under several hundred pounds of torque break arms and jaws when they slip. If you install it yourself, hire out the spring work.
Nearby
Also serving around Pantego
Book a visit that fits your day
New Garage Door Installation in Pantego and across Tarrant County.